R-KER-300
5906675075167
Polyester bonded anchor without styrene, recommended for medium loads, for use in concrete
Define product parameters:
Catalog price for pc:
PLN101.45
net | VAT 23
Contact with us and check out our terms of cooperation
Catalog price for pc:
PLN101.45
net | VAT 23
Contact with us and check out our terms of cooperation
Product info
Polyester bonded anchor without styrene, recommended for medium loads, for use in concrete
Jak prawidłowo użyć kotwy chemicznej?
Jaką kotwę chemiczną wybrać?
Czym jest kotwa chemiczna i jak jej używać?
Rawlplug R-KER Vinylester Resin - Rebar Installation
Rawlplug R-KER Styrene Free Vinylester Resin and Rebar
Approved surfaces
Design Consulting
Resin calculator
E-learning training
Training at the Rawlplug Academy center
Blow out the dust at least 4 times with the hand pump.
Drill a hole to the required diameter and depth for rebar size being used.
Clean drilled hole 4 times.
Remove drill cuttings from the hole using the hand pump four times.
Place the cartridge in the dispenser.
Dispense to waste until even colour is obtained.
Fill with resin 70% of the depth of the hole, starting from the bottom of the hole.
Immediately after dispensing the resin, insert the rod into the hole with a twisting motion.
Remove the unnecessary amount of resin that flowed from the hole and wait for the appropriate time for the resin to cure.
Immediately insert the rebar, slowly and with slight twisting motion. Remove any excess resin around the hole before it sets and leave it undisturbed until the curing time elapses.
Place the bar in the hole and allow the setting time to elapse.
Attach fixture and tighten the nut to the required torque.
Drill a hole of appropriate diameter and depth.
Wydmuchać pył co najmniej 4 razy przy pomocy ręcznej pompki.
Usunąć zwierciny z otworu za pomocą czterokrotnego użycia wyciora
R_KEX_385_stud_inst_draw_04
Umieścić kartridż w dozowniku i przymocować dyszę mieszającą
Rozpoczynając dozowanie z nowego opakowania odrzucić część żywicy, aż do uzyskania jednakowego koloru mieszanki
Insert the mixing nozzle to the far end of the hole and inject resin, slowly withdrawing the nozzle as the hole is filled to 70% of its depth.
Immediately after dispensing the resin, insert the rod into the hole with a twisting motion.
Leave the anchor undisturbed unitl the curing time elapses.
Reinforcing bar is properly installed in the concrete base.