R-NOZ-100/100
5010445606427
Static mixer for bonded anchors in cartridges and CFS+ system
Define product parameters:
Catalog price for bx:
PLN512.00
net | VAT 23
Contact with us and check out our terms of cooperation
Catalog price for bx:
PLN512.00
net | VAT 23
Contact with us and check out our terms of cooperation
Product info
Static mixer for bonded anchors in cartridges and CFS+ system
Approved surfaces
Drill a hole to the required diameter and depth for rebar size being used.
Choose extensions and brushes to the selected depth and diameter of the hole, then combine them into one set.
Before inserting anchor, clean inside of hole by commpresed air starting from the drill holle botton. Blow the hole at least twice by compressed air at minimum 6 bar.
Choose extensions and brushes to the selected depth and diameter of the hole, then combine them into one set.
Connect the drill set with the SDS tip.
Before inserting anchor, clean inside of hole by commpresed air starting from the drill holle botton. Blow the hole at least twice by compressed air at minimum 6 bar.
Drill a hole to the required diameter and depth for rebar size being used.
Place the sleeve in the hole.
Place the threaded rod in the sleeve and wait until the resin is fully cured according to the information on the package.
Dispense resin 100% of the hole depth and close the sleeve plug.
After full curing of the anchor, install the fixed element with a proper torque.
Fill hole with the required resin to the recommended fill level. (Follow the relevant instructions for the resin product).
Insert the threaded stud slowly and with a slight twisting motion, until the required embedment depth is reached.
Leave to solidify for the time required for the application.
Attach fixture and tighten the nut to the required torque.
Item is properly attached.
