1. Mainpage
  2. MBASS Metal Insulation Fixing 8 x 50mm, Stainless Steel, Class A1 Fire Rating - cardboard box - 250 pcs.

MBASS Metal Insulation Fixing 8 x 50mm, Stainless Steel, Class A1 Fire Rating - cardboard box - 250 pcs.

Universal
Outlet

MBA-SS-08050

5906675505862

Fire-resistant metal insulation fixing

Define product parameters:

Material type
Length
Packaging and quantity

Features

Fire-resistant metal insulation fixing

  • Accessory spreader plate, MKC-SS (85mm diameter) also available for installation of soft insulation materials such as mineral wool.
  • Metal facade fixing, recommended for use when fire resistance (F120) is a requirement.
  • Extensive dimensional range allows anchorage of insulation boards up to 250mm thick.
  • Fast and simple hammer-set installation reduces working times.
  • Stainless steel material for high corrosion resistance.

Product video

R_MBA_monta_zag__bionywwe_niemineralnej

R_MBA_monta_powierzchniowywwe_niemineralnej

Krok_po_kroku_jak_montowac_kolki_fasadowe_z_trzpieniem_wbijanym

Substrates

Concrete C20/25-C50/60 (Use category A)

Concrete C20/25-C50/60 (Use category A)

Solid brick (Use category B)

Solid brick (Use category B)

Solid sand-lime brick (Use category B)

Solid sand-lime brick (Use category B)

Ceramic hollow block

Ceramic hollow block

Aerated concrete

Aerated concrete

Aerated concrete block (Use category D)

Aerated concrete block (Use category D)

Hollow sand-lime brick ≥ 15MPa

Hollow sand-lime brick ≥ 15MPa

Approved surfaces

Applications

Facades - thermal insulation systems

Services

Design Consulting

Design Consulting

E-learning training

E-learning training

Technical Support 2

Technical Support 2

Rawlplug Academy

Rawlplug Academy

Installation guide

Installation manual

Installation step by step

1

Drill hole to the required diameter and depth for rebar size being usee

2

Blow out dust at least 3 times with a hand pump.

3

Gently drive the MBA steel connector (with MKI plate) into the hole until the connector is anchored to the correct depth.

4

Correctly installed steel facade fixing.

5

Cut the hole in insulation board.

6

Drill a hole of appropriate diameter and depth.

7

Clean drilled hole 3 times.

8

Gently drive the steel dowel into the hole until the correct anchorage depth for the fastener is achieved. For soft substrates, use the MKC 85 mm steel washer.

9

Insert cap into countersunk hole in insulation board following installation of the facade fixing.

10

Correctly installed steel facade fixing.

Installation data

Approvals and publications

Technical library and approvals

Choose document:

KOT_RAWLPLUG_MBA_R_MBA

020-UWB-0702/Z

KDWU_2018_0721_6_MBA_FACADE_FIXINGS_EN_1_

Product card and catalogues

Choose product card:

Product card

Product card

Choose product catalog:

Specification Design Guide

General catalogue - PDF