Drill a hole to the required diameter and depth for rebar size being used.

Choose extensions and brushes to the selected depth and diameter of the hole, then combine them into one set.

Choose extensions and brushes to the selected depth and diameter of the hole, then combine them into one set.

Before inserting anchor, clean inside of hole by commpresed air starting from the drill holle botton. Blow the hole at least twice by compressed air at minimum 6 bar.

Connect the drill set with the SDS tip.

Before inserting anchor, clean inside of hole by commpresed air starting from the drill holle botton. Blow the hole at least twice by compressed air at minimum 6 bar.

Place the cartridge in the dispenser.

When starting dispensing from a new package, discard approximately 10-15 cm of unmixed resin.

Fill hole with the required resin to the recommended fill level. (Follow the relevant instructions for the resin product).

Insert the threaded stud slowly and with a slight twisting motion, until the required embedment depth is reached.

Leave to solidify for the time required for the application.

Attach fixture and tighten the nut to the required torque.

Item is properly attached.