Rawlplug Shield Anchor, Loose Head, M10 x 140mm, Non-Approved - cardboard box - 25 pcs.

Drill a hole to the required diameter and depth for rebar size being used.

Blow out the dust at least 4 times with the hand pump.

Insert the anchor (tap home until flush with surface) and position hook accordingly.

Using a torque wrench, tighten the anchor with the nut (not the hook) to the required torque

The anchor is correctly installed

Insert the anchor (tap home until flush with surface) and position hook accordingly.

Insert the screw with the washer through the fastened element to the sleeve placed in the hole. Using a torque wrench, tighten the nut to the required torque.

The anchor is properly fixed in the concrete base.

Remove pre-assembled bolt and washer. Insert shield into hole and tap home with hammer until flush with surface.

Używając klucza dynamometrycznego dokręcić kotwę nakrętką (nie hakiem) z wymaganym momentem obrotowym

The anchor is correctly installed

Drill a hole of required diameter and depth. Note: When fixing into brickwork, mortar joints should be avoided.

Remove pre-assembled bolt and washer. Insert shield into hole and tap home with hammer until flush with surface.

Insert the screw with the washer through the fastened element to the sleeve placed in the hole. Using a torque wrench, tighten the nut to the required torque.

The anchor is properly fixed in the concrete base.

Drill a hole to the required diameter and depth for rebar size being used.

Remove pre-assembled bolt and washer. Insert shield into hole and tap home with hammer until flush with surface.

Insert the screw with the washer through the fastened element to the sleeve placed in the hole. Using a torque wrench, tighten the nut to the required torque.

The anchor is properly fixed in the concrete base.