Solid walls
RBL2-M12/60W
5010445006630
For use in hollow core slab and ceramic substrates
Define product parameters:
Diameter
Maximum thickness of the mounted element
Packaging and quantity
Contact with us and check out our terms of cooperation
Contact with us and check out our terms of cooperation
Related products
Features
For use in hollow core slab and ceramic substrates
- Three-pieces expanding sleeve of maximum expansion provides optimal load and safety of use in any substrate.
- For use in cracked and non-cracked concrete, hollow-core slabs, flooring blocks and ceramics.
Approved surfaces
Diameter | Maximum thickness of the mounted element | Packaging and quantity | Index | EAN | Catalog price for PAC. net |
|---|
Installation manual
Installation step by step
1
Drill a hole to the required diameter and depth for rebar size being used.
2
Blow out the dust at least 4 times with the hand pump.
3
Insert the anchor (tap home until flush with surface) and position hook accordingly.
4
Using a torque wrench, tighten the anchor with the nut (not the hook) to the required torque
5
The anchor is correctly installed
6
Insert the anchor (tap home until flush with surface) and position hook accordingly.
7
Insert the screw with the washer through the fastened element to the sleeve placed in the hole. Using a torque wrench, tighten the nut to the required torque.
8
The anchor is properly fixed in the concrete base.
9
Remove pre-assembled bolt and washer. Insert shield into hole and tap home with hammer until flush with surface.
10
Używając klucza dynamometrycznego dokręcić kotwę nakrętką (nie hakiem) z wymaganym momentem obrotowym
11
The anchor is correctly installed
12
Drill a hole of required diameter and depth. Note: When fixing into brickwork, mortar joints should be avoided.
13
Remove pre-assembled bolt and washer. Insert shield into hole and tap home with hammer until flush with surface.
14
Insert the screw with the washer through the fastened element to the sleeve placed in the hole. Using a torque wrench, tighten the nut to the required torque.
15
The anchor is properly fixed in the concrete base.
16
Drill a hole to the required diameter and depth for rebar size being used.
17
Remove pre-assembled bolt and washer. Insert shield into hole and tap home with hammer until flush with surface.
18
Insert the screw with the washer through the fastened element to the sleeve placed in the hole. Using a torque wrench, tighten the nut to the required torque.
19
The anchor is properly fixed in the concrete base.
Installation data
Catalogues and product cards
(4)