RPP-PVC
5906675284064
Define product parameters:
Unit pack
12.00 pcs.10.83 kg
Bulk pack
12.00 pcs.10.83 kg
Pallet
672.00 pcs.
Contact with us and check out our terms of cooperation
Contact with us and check out our terms of cooperation
Low-pressure, one-component polyurethane foam for PVC with gun applicator
Approved surfaces
Design Consulting
Training at the Rawlplug Academy center
Designing
E-learning training
Put on protective gloves and thoroughly clean the working surface to remove dust, dirt, and grease. Remove any frost from the working substrate. Before use, ensure that the can is at a positive temperature. The optimum can temperature is +20°C.
Application temperature from +5°C to +30°C.
Shake the can vigorously (approx. 30 seconds) to thoroughly mix the ingredients.
Attach the gun to the can. The working position should be "upside down".
Moisten the surfaces to be applied with water.
Fill the gaps from bottom to top in a zigzag pattern, alternating from one side to the other. Fill the gaps up to 60% of their depth, but not more than 3-4 cm per layer. For gaps wider than 3-4 cm, fill them in layers, after the previous layer has hardened. After applying each layer, moisten it with water using a sprayer. After full curing, trim off any excess foam with a knife and protect it from UV rays by covering it with plaster, paint, acrylic, or silicone. If there is a pause longer than five minutes, clean the applicator nozzle with a foam cleaner. When removing the gun from the can, clean both the nozzle and the gun (both externally and internally) with a cleaner.
