Wedge anchor setting tools - R-DCA-ST-II M10x17 mm, I Generation - label - 1 pc.
R-DCA-ST-II-10-25
5906675430782
Manual setting tool
Define product parameters:
Contact with us and check out our terms of cooperation
R-DCA-ST-II-10-25
5906675430782
Manual setting tool
Define product parameters:
Contact with us and check out our terms of cooperation
Contact with us and check out our terms of cooperation
Manual setting tool
Cracked concrete C20/25-C50/60
Non-cracked concrete C20/25-C50/60
Solid concrete block
Granite
High-density natural stone
Approved surfaces
Air conditioning / ventilation
Ceiling mounts
Sanitary and gas installations
Sprinkler installations
Steel structures
Swings
Pipelines
Design Consulting
Training at the Rawlplug Academy center
E-learning training
Learn moreTechnical Support 2
Drill hole to the required diameter
Clear the hole of drilling dust and debris (using blowpump or equivalent method)
Tap on the sleeve anchor with a skein
Place the punch into the hole in the sleeve anchor
By using a hammer and a hammer, the anchor is correctly installed in the hole
Mechanical anchors - introduction and correct installation of anchors - ON-SITE TRAINING
Mechanical anchors - Rawlplug's offer - ON-SITE TRAINING
Mechanical anchors - introduction and correct installation of anchors - TRAINING CENTER
Mechanical anchors - Rawlplug's offer - TRAINING CENTER
Mechanical anchors - introduction and correct installation of anchors - WEBINAR
Mechanical anchors - Rawlplug's offer - WEBINAR