All-season polyurethane gun foam Koelner - metal can - 750 ml
RPP-45-K
5906675143392
Low-pressure, one-component polyurethane foam with gun applicator
Define product parameters:
Contact with us and check out our terms of cooperation
RPP-45-K
5906675143392
Low-pressure, one-component polyurethane foam with gun applicator
Define product parameters:
Contact with us and check out our terms of cooperation
Contact with us and check out our terms of cooperation
Low-pressure, one-component polyurethane foam with gun applicator
Structural steel
Concrete
Metal sheet & profiles
Wood
Masonry
PVC Profile
Concrete slab
Hollow-core slab
High-density natural stone
Plasterboard
Chipboard
Stainless steel
Solid concrete block
Aerated concrete
Solid brick
Oriented strand board
Gypsum fibreboards
Lightweight concrete block
Silicate blocks
Solid sand-lime brick
Hollow lightweight concrete block
Hollow brick
Hollow sand-lime brick
Vertically-perforated clay block
Ceramic hollow block
Approved surfaces
Air conditioning / ventilation
Doors and windows
Facades - thermal insulation systems
Pitched roofs
Sanitary and gas installations
Sealing
Wooden constructions
Put on protective gloves and thoroughly clean the working surface to remove dust, dirt, and grease. Remove any frost from the working substrate. Before use, ensure that the can is at a positive temperature. The optimum can temperature is +20°C.
Application temperature from -10°C to +30°C.
Shake the can vigorously (approx. 30 seconds) to thoroughly mix the ingredients.
Screw straw-applicator onto the can. Hold can upside-down during application.
Fill the gaps from bottom to top in a zigzag pattern, alternating from one side to the other. Fill the gaps up to 60% of their depth, but not more than 3-4 cm per layer. Gaps wider than 3-4 cm should be filled in layers, after each preceding layer has hardened. After the foam has fully cured, use a knife to cut off any excess and protect it from UV rays by covering it with plaster, paint, acrylic, or silicone. If there is a pause longer than five minutes, clean the applicator nozzle with a foam cleaner. When removing the gun from the can, clean both the nozzle and the gun (both externally and internally) with a cleaner.
Foams - general characteristics - E-LEARNING
Foams - detailed characteristics of hose and pistol foams - E-LEARNING
Foam - Rawlplug's offer - ON-SITE TRAINING
Rawlplug's offer - TRAINING CENTER
Webinar voucher - Foam - Rawlplug's offer