RPP-65-K
5906675393698
High Yield, low-pressure, one-component polyurethane foam with gun applicator
Define product parameters:
Unit pack
12.00 pcs.11.87 kg
Bulk pack
12.00 pcs.11.87 kg
Pallet
672.00 pcs.689.78 kg
Contact with us and check out our terms of cooperation
Contact with us and check out our terms of cooperation
High Yield, low-pressure, one-component polyurethane foam with gun applicator
Approved surfaces
Packaging and quantity | Index | EAN | Catalog price for pc. net |
|---|
Wear protective gloves. Shake the can vigorously (approx. 30 seconds) to thoroughly mix the ingredients.
Application temperature from -10°C to +30°C.
Shake the can vigorously (approx. 30 seconds) to thoroughly mix the ingredients.
Screw gun on to the can. Hold can upside-down during application.
Moisten the surfaces to be applied with water.
Fill the gaps from bottom to top in a zigzag pattern, alternating from one side to the other. Fill the gaps up to 60% of their depth, but not more than 3-4 cm per layer. Gaps deeper than 4 cm should be filled in layers, after each preceding layer has hardened. After the foam has fully cured, use a knife to cut off any excess and protect it from UV rays by covering it with plaster, paint, acrylic, or silicone. If there is a pause longer than five minutes, clean the applicator nozzle with a foam cleaner. When removing the gun from the can, clean both the nozzle and the gun (both externally and internally) with a cleaner.
