K-P3-PLS-12050-10
5906675318370
Define product parameters:
Unit pack
140.00 pcs.0.27 kg
Bulk pack
140.00 pcs.0.27 kg
Pallet
8400.00 pcs.16.38 kg
Contact with us and check out our terms of cooperation
Contact with us and check out our terms of cooperation
The sleeve for reduced resin consumption and optimal mechanical interlock
Installation and use of polyester chemical anchor – Rawlplug's tutorial
Approved surfaces
Diameter | Length | Type of package | Piece. per pack. | Index | EAN | Catalog price for pc. net |
|---|
Drill a hole to the required diameter and depth for rebar size being used.
Choose extensions and brushes to the selected depth and diameter of the hole, then combine them into one set.
Before inserting anchor, clean inside of hole by commpresed air starting from the drill holle botton. Blow the hole at least twice by compressed air at minimum 6 bar.
Choose extensions and brushes to the selected depth and diameter of the hole, then combine them into one set.
Connect the drill set with the SDS tip.
Before inserting anchor, clean inside of hole by commpresed air starting from the drill holle botton. Blow the hole at least twice by compressed air at minimum 6 bar.
Drill a hole to the required diameter and depth for rebar size being used.
Place the sleeve in the hole.
Place the threaded rod in the sleeve and wait until the resin is fully cured according to the information on the package.
Dispense resin 100% of the hole depth and close the sleeve plug.
After full curing of the anchor, install the fixed element with a proper torque.
Fill hole with the required resin to the recommended fill level. (Follow the relevant instructions for the resin product).
Fill hole with the required resin to the recommended fill level. (Follow the relevant instructions for the resin product).
Leave to solidify for the time required for the application.
Attach fixture and tighten the nut to the required torque.
Attach fixture and tighten the nut to the required torque.
