KEM-VSF-300-KOE
5906675408019
Hybrid bonded anchor for high loads based on styrene-free vinylester resin for concrete substrates
Define product parameters:
Contact with us and check out our terms of cooperation
Contact with us and check out our terms of cooperation
Hybrid bonded anchor for high loads based on styrene-free vinylester resin for concrete substrates
Approved surfaces
Design Consulting
Resin calculator
Training at the Rawlplug Academy center
Technical Support 2
Blow out the dust at least 4 times with the hand pump.
Drill a hole to the required diameter and depth for rebar size being used.
Clean drilled hole 4 times.
Remove drill cuttings from the hole using the hand pump four times.
Place the cartridge in the dispenser.
Dispense to waste until even colour is obtained.
Fill with resin 70% of the depth of the hole, starting from the bottom of the hole.
Immediately after dispensing the resin, insert the rod into the hole with a twisting motion.
Remove the unnecessary amount of resin that flowed from the hole and wait for the appropriate time for the resin to cure.
A bonded anchor with a threaded rod is correctly installed in the concrete substrate.
