Professional gun for foam - cardboard box - 1 pc.
RPP-GUN-NC
5906675379203
Professional gun applicator for polyurethane foams
Define product parameters:
Contact with us and check out our terms of cooperation
RPP-GUN-NC
5906675379203
Professional gun applicator for polyurethane foams
Define product parameters:
Contact with us and check out our terms of cooperation
Contact with us and check out our terms of cooperation
Universal gun foam, EN label - metal can - 750 ml
PU foam cleaner, EN label - metal can - 500 ml
STYROfix adhesive for polystyrene, EN label - metal can - 750 ml
Universal gun foam, FR label - metal can - 750 ml
Fireproof gun foam, EN label - metal can - 750 ml
Universal hand held foam, FR label - metal can - 500 ml
Low-pressure gun foam for PVC, EN label - metal can - 750 ml
Instant adhesive 60 seconds - metal can - 750 ml
Super efficient gun foam, EN label - metal can - 830 ml
R-PGL Protective gloves for power tools 10" blue - paper hanger - 1 pc.
STYROfix adhesive for polystyrene, FR label - metal can - 750 ml
Low-pressure gun foam for PVC, FR label - metal can - 750 ml
Professional gun applicator for polyurethane foams
Structural steel
Concrete
Concrete slab
Solid brick
Solid sand-lime brick
Silicate blocks
Hollow brick
Vertically-perforated clay block
Hollow sand-lime brick
Ceramic hollow block
Ceramic hollow blocks in high dimensional tolerance class TLMB
Hollow lightweight concrete block
Solid concrete block
Silicate blocks in high dimensional tolerance class TLMB
Aerated concrete
Aerated concrete in TLMB dimensional tolerance class
Wood
Chipboard
Plasterboard
Gypsum fibreboards
Masonry
PVC Profile
Approved surfaces
Construction work
Finishing works
Doors and windows
Fire seals
Flat roofs
Masonry structures
Pitched roofs
Design Consulting
Training at the Rawlplug Academy center
E-learning training
Learn moreTechnical Support 2
Shake can vigorously for 30 seconds to mix properly components.
Screw the gun to the can. The working position during assembly should be the "upside down" position of the can.
Fill the gaps from bottom to top, in a zigzag pattern, alternating from one side to the other. Fill the gaps up to 60% of the depth, but not more than 5 cm per layer. Gaps wider than 5 cm should be filled in layers, after the previous layer has hardened.
When work is finished, there is a possibility to leaving the can connected with the gun. To avoid accidental foam application block the handweel.
Disconnect the gun from the can with PU foam. Spray basket of gun using Rawlplug PU Foam Cleaner.
Screw the can with the cleaner on the gun to avoid curing the foam inside the gun. Then press the gun lever several times until the internal parts of the gun are completely cleaned of PU foam. If the foam hardens in the gun, the cleaner will not dissolve it. Never use water to clean the gun. Cured foam in the gun renders it unusable. It can be removed mechanically after disassembling the gun. To do this, unscrew the adjusting screw and pull out the needle. Before reassembling, clean the needle with a cleaner and lubricate it before inserting it into the gun. Dry all cleaned surfaces thoroughly.".
Gun cleaning: - Disconnect the gun from the PU foam container and remove the remaining PU foam from the gun by pressing the gun lever.