PLS Plastic sleeve 16x85 mm - label - 1 pc.
Universal
K-P3-PLS-16085-10
5906675383880
Define product parameters:
Diameter
Length
Packaging and quantity
Contact with us and check out our terms of cooperation
Contact with us and check out our terms of cooperation
Related products
Features
The sleeve for reduced resin consumption and optimal mechanical interlock
- Ensures that the anchor rod is properly centred
- Threaded rod made of hot dip galvanized steel is suitable for outdoor use and in damp conditions
- Size must be adjusted to the hole depth and diameter
- Suitable for variable anchor embedment depths.
- Reduces consumption of resin
- Ideal for cleaning dust from drilled holes prior to applying bonded anchors or installing mechanical anchors
- Hole cleaning is not necessary
- Suitable for variable anchor embedment depths.
Product video
Installation and use of polyester chemical anchor – Rawlplug's tutorial
Substrates
Approved surfaces
Applications
Services
Installation guide
Installation manual
Installation step by step
1
Drill a hole to the required diameter and depth for rebar size being used.
2
Choose extensions and brushes to the selected depth and diameter of the hole, then combine them into one set.
3
Before inserting anchor, clean inside of hole by commpresed air starting from the drill holle botton. Blow the hole at least twice by compressed air at minimum 6 bar.
4
Choose extensions and brushes to the selected depth and diameter of the hole, then combine them into one set.
5
Connect the drill set with the SDS tip.
6
Before inserting anchor, clean inside of hole by commpresed air starting from the drill holle botton. Blow the hole at least twice by compressed air at minimum 6 bar.
7
Drill a hole to the required diameter and depth for rebar size being used.
8
Place the sleeve in the hole.
9
Place the threaded rod in the sleeve and wait until the resin is fully cured according to the information on the package.
10
Dispense resin 100% of the hole depth and close the sleeve plug.
11
After full curing of the anchor, install the fixed element with a proper torque.
12
Fill hole with the required resin to the recommended fill level. (Follow the relevant instructions for the resin product).
13
Fill hole with the required resin to the recommended fill level. (Follow the relevant instructions for the resin product).
14
Leave to solidify for the time required for the application.
15
Attach fixture and tighten the nut to the required torque.
16
Attach fixture and tighten the nut to the required torque.