Rigid extension for R-BRUSH-TC - plastic bag - 1 pc.
R-BRUSH-EXT-H-TC
5906675436104
Define product parameters:
Contact with us and check out our terms of cooperation
R-BRUSH-EXT-H-TC
5906675436104
Define product parameters:
Contact with us and check out our terms of cooperation
Contact with us and check out our terms of cooperation
Polyester bonded anchor R-KEM-II standard - plastic cartouche - 300 ml
Epoxy bonded anchor R-KEX-II 3:1 - plastic cartouche - 600 ml
Hybrid bonded anchor R-KER-II standard - plastic cartouche - 400 ml
Pump for blowing drill cuttings - plastic bag - 1 pc.
Metal brush for cleaning holes M16 - label - 1 pc.
Metal brush for cleaning holes M12 - label - 1 pc.
R-BRUSH Steel brush for cleaning of deep holes, 14mm - plastic box - 1 pc.
R-BRUSH Steel brush for cleaning of deep holes, 12mm - plastic box - 1 pc.
Rigid extension for automatic cleaning of deep holes in a solid substrate
Jak prawidłowo wykonać głębokie wklejanie prętów zbrojeniowych?
Rawlplug Deep Anchorage and post-installed rebar accessories system
Concrete C12/15-C50/60
Approved surfaces
Anchoring glued in with reinforcing bars
Anchoring glued in with threaded rods
Concrete structures
Drilling
Reinforcement of a large slab
Extension for R-BRUSH-TC with a handle - label - 1 pc.
Extension for R-BRUSH-TC with thread - label - 1 pc.
Brush for cleaning holes M8/10 - label - 1 pc.
R-BRUSH Metal brush for cleaning holes for M8 rods - label - 1 pc.
Brush for cleaning holes M10/14 - label - 1 pc.
Metal brush for cleaning holes M12 - label - 1 pc.
Metal brush for cleaning holes M16 - label - 1 pc.
Metal brush for cleaning holes M20 - label - 1 pc.
Metal brush for cleaning holes M24 - label - 1 pc.
Metal brush for cleaning holes M30 - label - 1 pc.
Design Consulting
E-learning training
Learn moreTraining at the Rawlplug Academy center
Technical Support 2
Drill a hole to the required diameter and depth for rebar size being used.
Before inserting anchor, clean inside of hole by commpresed air starting from the drill holle botton. Blow the hole at least twice by compressed air at minimum 6 bar.
Choose extensions and brushes to the selected depth and diameter of the hole, then combine them into one set.
Connect the drill set with the SDS tip.
Before inserting anchor, clean inside of hole by commpresed air starting from the drill holle botton. Blow the hole at least twice by compressed air at minimum 6 bar.