R-CFS+KERII-600-W
5906675478050
Define product parameters:
Contact with us and check out our terms of cooperation
Contact with us and check out our terms of cooperation
Bonded anchor based on hybrid resin in 600ml foil loads, winter version
R-KER II bonded anchor – installation and application – how to use the product – Rawlplug tutorial
Rawlplug Deep Anchorage and post-installed rebar accessories system
Jak zamontować konstrukcję stalową?
Approved surfaces
Warranty
Customer service
BIM
Designing POS Displays
Drill a hole to the required diameter and depth for rebar size being used.
Blow out the dust at least 4 times with the hand pump.
Clean drilled hole 4 times.
Blow out the dust at least 4 times with the hand pump.
Place the foil pack in the squeezer.
When starting dosing from a new package, discard some of the resin until the mixture is uniform in color
Fill with resin 70% of the depth of the hole, starting from the bottom of the hole.
Immediately insert the rebar, slowly and with slight twisting motion. Remove any excess resin around the hole before it sets and leave it undisturbed until the curing time elapses.
Leave the anchor undisturbed unitl the curing time elapses.
The anchor is correctly fixed.
Immediately after dispensing the resin, place the rod in the hole and allow the resin to set properly.
Leave the anchor undisturbed unitl the curing time elapses.
Chemical anchor with the rod is correctly installed.
Screw the rod into the sleeve with internal thread placed in the hole.
Place the bar in the hole and allow the setting time to elapse.
Properly installed sleeve with internal thread in the concrete base.
