R-CFS+KERII-600-S
5906675464824
Define product parameters:
Contact with us and check out our terms of cooperation
Contact with us and check out our terms of cooperation
Bonded anchor based on hybrid resin in 600ml foil loads, summer version
R-KER II bonded anchor – installation and application – how to use the product – Rawlplug tutorial
Rawlplug Deep Anchorage and post-installed rebar accessories system
Jak zamontować konstrukcję stalową?
Approved surfaces
Warranty
Customer service
BIM
Designing POS Displays
Drill a hole to the required diameter and depth for rebar size being used.
Blow out the dust at least 4 times with the hand pump.
Clean drilled hole 4 times.
Wydmuchać pył co najmniej 4 razy przy pomocy ręcznej pompki.
Place the foil pack in the squeezer.
When starting dosing from a new package, discard some of the resin until the mixture is uniform in color
Fill with resin 70% of the depth of the hole, starting from the bottom of the hole.
Immediately after dispensing the resin, insert the rod into the hole with a twisting motion.
Remove the unnecessary amount of resin that flowed from the hole and wait for the appropriate time for the resin to cure.
A bonded anchor with a threaded rod is correctly installed in the concrete substrate.
Immediately after dispensing the resin, insert the rod into the hole with a twisting motion.
Leave the anchor undisturbed unitl the curing time elapses.
Reinforcing bar is properly installed in the concrete base.
Screw the rod into the sleeve with internal thread placed in the hole.
Place the bar in the hole and allow the setting time to elapse.
Properly installed sleeve with internal thread in the concrete base.
